Home->Products->MSB->PCI310

PCI310

Single-Site PCI Carrier; V3 PCI Chip-set; 200MB/sec Digital Bus and 1Mbyte of shared memory.

Overview

The PCI310 is a single site module carrier developed to provide access to a TIM Module over the PCI bus running at 33MHz with a 32-bit data bus. The card has an 'on-board' JTAG ACT8990 controller. This allows Code Composer Studio and 3L Diamond applications to be used to debug/upload software to a Module. A single buffered ComPort with conflict protection is available on the rear panel. This will have the versatility to access any of four ComPorts from the Module. The main connection to the half-length PCI bus is via the Module's Global Bus. A single ComPort is also mapped to the PCI bus providing support for application boot and data transfer. 1 Mbyte of SRAM is mapped on to the Global Bus and can be accessed by the Module as a global resource or by the PCI Bridge. A 3.3 volt supply is available at the fixing pillars for the Module. This supply is taken from the PCI edge connector. An 'on-board' 200MB/sec Digital Bus interface to the PCI Bridge allows the card to be interfaced to '200MB/sec Digital Bus' standard modules.

Key Features:

	Single module sites
	PCI 'master mode' (PCI DMA) support on one Comm-port
	Host interface bandwidth via global bus in excess of 100 Mbytes/s @ 33MHz PCI clock
	Host interface via ComPort in excess of 10 Mbytes/s
	Buffered External ComPort
	Expansion via interprocessor ComPort
	200MB/sec Digital Bus port for interface to other 200MB/sec Digital Bus compatible products
	1Mbyte Shared SRAM interface between PCI and Module
	512Kbytes FLASH ROM for configuration etc.
	On-board XDS-510 compatible JTAG Master
	12 months warranty

Benefits

	Reduce cost for simple applications
	Scaleable system configuration
	Low cost Multiprocessor resource
	Flexible Task allocation
	Expandable system allows for future expansion

Layout for the PCI310 (PDF):

CLICK for Block Diagram (PDF):

User Manual (PDF)

Send questions and comments to webmaster.