cPCI300Q
cPCI 6U carrier with 4
Module sites; PXI compatible; V3 PCI Chip-set; 200MB/sec bus and 1Mbyte of shared memory
on master site
Overview | Features |
Benefits | Layout |
Block Diagram | User
Manual
The cPCI300Q is a quad site module
carrier developed to provide access to a TIM Modules over the CompactPCI bus
running at 33MHz with a 32-bit data bus.
The card has an 'on-board' JTAG
ACT8990 controller. This allows
Code Composer Studio and
3L Diamond applications to be used to debug/upload software to Modules.
A single buffered comm-port with conflict protection is available on the chassis
front panel. This has the versatility to access any of four com-ports from the
Modules.
The main connection to the CompactPCI bus is via the Module's Global Bus. A
single comm-port is mapped to the CompactPCI bus providing support for
application boot and data transfer.
A 1 M Byte of SRAM is mapped on to the Global Bus and can be accessed by the
Modules as a global resource or by the CompactPCI Bridge.
A 3.3 volt supply is available at the fixing pillars for the Modules. This
supply will be taken from the CompactPCI edge connector.
An 'on-board' 200MB/sec Digital Bus interface to the CompactPCI bridge
allows the card to be interfaced to other 200MB/sec Digital Bus standard modules.
PCI Extensions for Instrumentation (PXI) signals are utilised allow multiple
cPCI300Q's to be synchronised in a system.
 | Quad module sites |
| PCI 'master mode' (PCI DMA)
support on one Comm-port |
| Host interface bandwidth via
global bus in excess of 100 Mbytes/s @ 33MHz PCI clock |
| Host interface via comm-port
in excess of 10 Mbytes/s |
| Six Buffered External Comm-port
|
| Expansion via interprocessor
comm-ports |
| 200MB/sec Digital Bus port for
interface to other 200MB/sec Digital Bus compatible products |
| 1Mbyte Shared SRAM interface
between PCI and Module |
| 512Kbytes FLASH ROM for
configuration etc. |
| On-board XDS-510 compatible
JTAG Master |
| 12 months warranty
|
